BendPak BB 1302-BA, Operation And Service Manual

Page: 10 / 72

END-FINISHING TOOLS - A variety of End Finishing
Tools are available that perform different functions. Not
every Tool is included with your Tooling package. If you
are unsure as to what was included, please consult your
distributor or review the delivery receipt and invoice. Each
Tool is marked with the appropriate size.
HPF-300- A Tool for making 45 and 90 degree Flanges on
Pipe Ends. Usually for Manifold connections.
DD-134/212- A Tool for Doming Pipe Ends or making Male
Ball Expansions when used in conjunction with the Male
Ball Expanders.
DD-134/212 & BFED-200/214 - Tools for flaring pipe ends
to make Female Ball Expansions. Each Tool is “stepped”
and has the ability to flare two different sizes. The BFED-
134/214 is used for Tubing sizes 1-3/4” and 2-1/4” while
the BFED-200/212 is used for Tubing sizes 2” and 2-1/2”.
B-212 - A Tool used for making Male Ball Expansions on
2-1/2” Pipe Ends.
CFT-200 & CFT-214 - Tools for making Manifold Flanges
on 2” and 2-1/4” Pipe Ends. Not included in standard
Tooling packages.
REDUCING TOOLS - Reducing Tools are used for
reducing or “shrinking” Pipe Ends to exact outside
diameters. Each Tool is marked with the appropriate size.
It is important to understand that the size marked on the
Tool will be the size that the Tubing will be reduced
down
to. For example, a Tool marked 200 will reduce 2-1/4”
Tubing down to 2” O.D. and a Tool marked 214 will
reduce 2-1/2” Tubing down to 2-1/4” O.D.
Not included in standard tooling packages.
SEGMENT EXPANDERS - Segment Expanders or
“Segment Sets” come in a variety of sizes and shapes,
each performing it's own distinct function. Segment Sets
are used for short pieces of Tubing or when the Tubing
end is minimized due to an existing bend. They can also
be used to expand Tubing that is deformed in such a man-
ner that will not permit use of the Swaging Expander.
Segment Sets are used in conjunction with an Arbor or
Mandrel. All Segment Sets are identified by grooved rings
located at the bottom as described on the following Chart
10 Bender Operation Manual
CAUTION!
DO NOT attempt to use these Tools unless you
have read and fully understand the “Swaging and
End Forming” section.
CAUTION!
ALWAYS wear protective safety glasses or goggles
when using this machine.
IMPORTANT NOTICE
Installing Headers on any motor vehicle is illegal in
most states and may violate the 1990 Clean Air Act.
Consult the EPA at (202) 260-7645 for questions
regarding the installation of any aftermarket perfor-
mance product that may alter vehicle emissions.
HPF-300 DD-134/212
Reducing Tool
BFED-134/214 BFED-200/212
B-212
CFT-200