BENDIX XVision, Manual

Page: 8 / 28

8
AIMING ADJUSTER TOOL
The aiming adjuster tool is included with the XVision
®
system
kit, but cannot be ordered individually. It is the only tool that
should be used to install the IR camera onto the
aiming adjusters.
IR CAMERA/ DISPLAY COMBINATION
The IR camera and display are serviceable and can be
ordered individually. The IR camera/display combination can
be purchased as an entire XVision
® system.
IR Camera (piece no. 5008214, service piece no. 801150)
The IR camera must always be mounted externally to the
vehicle and attaches to the standoff pivot assembly and
aiming adjusters on the IR camera bracket. The IR camera
is operational within the range of -40°C to 60°C.
The IR camera has two electrical connections: a 6-pin
IR camera connector and a 2-pin window heater connector.
Video Display (piece no. 5010210, service piece no.
801154)
– The display is operational within the range of
-40°C to 60°C. During power-up, the Bendix ® icon will be
displayed in the combiner for approximately 45 seconds.
The intensity control will need to be adjusted according to
light conditions and driver preference. After the initial
warm-up, the IR camera’s field of view (FOV) will be displayed
in the combiner.
The orientation of the virtual image on the display will depend
on the display mounting style that you have chosen. On the
bottom of the display, under a switch cover, there are four
dual inline position (DIP) switches which allow you to rotate
or invert the image. To access the DIP switches, slide the
cover away from the 25-pin connector. Displays arrive from
the factory with the DIP switches configured for the CB style
dashboard mount. Refer to Table 5 for the DIP switch settings
appropriate for your mount.
FIGURE 14 - DISPLAY DIP SWITCHES FOR DASHBOARD
MOUNT
TABLE 5 - DIP SWITCH POSITIONS
Fold Mirror
Intensity
Control
Combiner
25-pin Connector
On/Off
Switch
Video In/Out
Switch
FIGURE 13 - DISPLAY (SHOWN IN CB STYLE MOUNT
(DASHBOARD) POSITION WITH DISPLAY HARNESS)
n o it i s o P g n it n u o M
o e d i V
t a m r o F
s n o it i s o P h c ti w S P I D
1 2 3 4
d e t n u o M h s a D ) C S T N ( A / N F F O N O N O
d e t n u o M d a e h r e v O ) C S T N ( A / N F F O F F O F F O
Window
Heater
Connection
Aiming
Adjuster
Mounting
IR Camera
Connection
Standoff Pivot
Mounting
FIGURE 12 - IR CAMERA