BENDIX XVision, Manual

Page: 13 / 28

13
Replacing the Aiming Adjusters
1. Unlock the IR camera by turning the two IR camera
aiming adjusters and the IR camera standoff
1/4 turn counterclockwise.
2. Remove the IR camera from the IR camera bracket to
get easier access to the connectors.
3. Disconnect the 6-pin IR camera connector and the 2-pin
window heater connector of the IR camera harness from
the IR camera. Cut the cable tie to allow access. Refer
to Figure 24.
6. Replace the damaged parts with the new aiming adjusters
and standoff pivot assembly that were received with the
service kit (piece no. 5010079).
NOTE: The IR camera bracket can only be ordered
as a component of the IR camera bracket kit. However,
the components that attach to the IR camera bracket
to aim and adjust the IR camera can each be ordered
in the aiming adjuster replacement kit. The kit includes
the items below.
standoff pivot assembly (QTY 1) – fastens to the IR
camera standoff base with a maximum torque of
16 in-lbs.
standoff base (QTY 1) – fastens to the IR camera
bracket with #10 Plastite ® Hex ® flange head screw
and lockwasher with a maximum torque of
18-20 in-lbs.
aiming adjusters (QTY 2) – latch the IR camera into
position on the IR camera bracket and allow the IR
camera forward FOV to be adjusted horizontally and/
or vertically. The adjustment screw head(s)
accommodate an E8 external Torx
®
or a T15 internal
Torx
®
tool. (The aiming adjusters are fastened to the
IR camera bracket and torqued to 18 in-lbs. with four
#8-32
Hex
®
/Torx
®
screws.
7. Install the new aiming adjuster(s) using the #8-32
Hex
®
/Torx
®
screws. Torque the screws to 18 in-lbs.
8. Install the new standoff pivot assembly using the #10
lock washer and Plastite
®
Hex
®
flange head screw.
Torque the screw to 16 in-lbs.
4. Remove the #8-32 Hex ® /Torx ® screws from the damaged
aiming adjuster(s). Refer to Figure 25.
5. Remove the Plastite
®
Hex
®
flange head screw and #10
lock washer from the damaged standoff pivot assembly.
FIGURE 24 - CONNECTING THE CAMERA HARNESSES
Cable Tie
6-pin connector
2-pin connector
FIGURE 25 - AIMING ADJUSTER REPLACEMENT
KIT COMPONENTS
Standoff Pivot
Assembly
(16 in-lbs.)
Standoff
Base
Aiming
Adjusters
#8-32
Hex
® / Torx ®
(18 in-lbs.)
#10 Plastite ® Hex ®
flange with lock
washer
(18-20 in-lbs.)