Bender LINETRAXX RCMS150, Manual

Page: 39 / 52

Overview Modbus registers (RCMS150-01 only)
39 RCMS150_D00259_01_M_XXEN/08.2021
Tab. 6.7: Modbus registers: Control commands
Notes Tab. 6.7
1) Flag to allow modification of important registers. Is automatically deactivated after five sec-
onds.
2) Manual test on corresponding channel. The duration of the test depends on the set response
times.
3) Reset the fault memory on the corresponding channel.
4) Loads all factory settings of the corresponding channel (e.g. parameters of channel 1: regis-
ters 32100 to 32124). Secured via register 59000.
5) Loads the following channel-independent factory settings without interface parameters:
– Register 1269: Installation location
– Register 16162: Time
– Register 16164: Time zone
– Register 16166: Summer time
– Secured via register 59000.
6) Loads the following channel-independent factory settings with interface parameters
(secured via register 59000)
– Register 1269: Installation location
– Register 16158: Modbus address
– Register 16159: Modbus baud rate
– Register 16161: Modbus parity/stop bit
– Register 16162: Time
– Register 16164: Time zone
– Register 16166: Summer time
7) The Power on LED flashes green quickly to identify the device more quickly in a cluster of
devices. Is automatically deactivated after one minute.
8) Output a test alarm on a measuring channel.
The test alarm is deactivated after 1 minute (= 0).
0
no test alarm/end test alarm
1…12 Output test alarm on corresponding channel/active
9) Perform an offset measurement on the corresponding channel.
Secured via register 59000.
59023 WO K1
Offset meas-
urement
UINT16
1 = Perform offset
measurement
—
9)
59024 WO K2 UINT16 —
59025 WO K3 UINT16 —
59026 WO K4 UINT16 —
59027 WO K5 UINT16 —
59028 WO K6 UINT16 —
59029…59999 Reserved
Register Property Description Format Setting range
Factory
setting
Comment