Bender B93100735, Manual

Page: 31 / 116

Commissioning and operation
31 PEM735_D00084_02_M_XXEN/06.2020
3. Does the measuring current transformer's maximum current correspond to
the nameplate information of the connected device?
5.5 Switching on
To switch the device on, follow the steps below:
1. Connect the supply voltage.
2. Set the language
The following figure illustrates the language setting schematically so that you can
easily set the language when you start working with the PEM735.
Fig. 5.2: Schematic language setting
The confirmation dialogue box is always in English.
3. Set the bus address/IP address (Settings > Ethernet).
4. Set the measuring current transformer ratio (Settings > Basic > CT Primary/Sec-
ondary or I4 Primary/Secondary).
5. Change the measuring current transformer's counting direction, if
ENTER
ENTER
(Password)
ENTER
ENTER
Language
ENTER
ESC
ENTER