20
Bend-Tech Dragon A400
Assembly Manual
Assembling the Dragon
03
Use a ½ in. socket and drill to remove the
major components of the machine. Tin
snips will be required to remove the Support
Beams. The middle three racks are secured
to the beams, use a 3/16 in. Allen wrench to
remove the racks. Only loosen the racks
enough to slide them out. Take care not to
damage the racks when moving them.
3.5 Moving the head into Position
The head of the machine is extremely heavy. Great care should be taken not to damage any
machine’s components during moving and installation.
Important
Remove all other contents of the crate before attempting to move the Head of the
machine.
Use a ½ in. socket and drill to remove the lag bolts securing the head of the machine to the
floor of the crate.
Approach the head of the machine from the front with the forklift. Position the forks under the
head in the indicated position. It is recommended the installer use fork extensions and lay
blocks of wood across the forks to support the beam of the machine.
! Danger !
The head of the machine is heavy. Bend-Tech does not recommend placing the
head of the machine manually. If the head falls or tips over it could cause severe
injury or death.
Carefully lift the head of the machine off the crate floor and slowly move it into position. Do not
set the head onto the floor at this time.
