24
Bend-Tech Dragon A400
Assembly Manual
Assembling the Dragon
03
5
4
Install the second Support Beam so that the end labeled 4 is attached to the first Support
Beam and Support Leg 4. If necessary, use a rubber mallet to seat the beam sections together.
The end labeled 5 will need to be supported until the tail of the machine is installed.
3.6.5 Set the Second and Third Rack
Locate the Rack labeled 2 and 3, and slide it into position. Ensure the end labeled 2 matches
up with the end of the first rack.
Locate the Rack labeled 3 and 4, and slide it into position. Ensure the end labeled 3 matches
up with the end of the second rack.
3.6.6 Fasten the Support Legs to the Beams
REQUIRED TOOLS & EQUIPMENT
•
3/16 in. Allen Wrench
• Magnetic Tool
Before installing the tail of the machine, secure
the Support Legs to the Support Beams using 1/4
- 20 x 5/8 in. Allen head screws and T-nuts. These
can be found in Hardware Bag No. 1.
Using the magnetic tool provided, slide the T-nut
behind the Support Leg brace until it aligns with
the mounting hole in the Support Leg. Insert the
Allen head screw and thread it into the T-nut,
using a 3/16 in. Allen wrench. Repeat this process
for all eight fasteners on each side of the Support
Legs. Do not tighten these yet.
T-Nut
Magnet Tool
1/4 -20 5/8 in. Allen
head screw
