Technical documentation
Rev. 02
Reactive Factor Controller CX plus
19
8 Operation:
The CX plus is operated using 4 keys.
NOTE
: If no key is pressed within 60 s, the backlighting is switched off. If the
backlighting is switched off, the backlighting is first switched on by pressing one of
the 4 keys.
There is only a reaction in the user menu when you press a key again.
Increase values, select the previous
measurement value, menu item and
step number
Exit menus,
moves the cursor to
the left,
reset alarms (keep the
key pressed for
approx. 3 s in order to
reset the alarm)
Open menus,
moves the cursor to
the right,
accept the set value
Reduce values, select the next
measurement value, menu item and
step number
Entering numerical values:
As the procedure for entering the numerical values is always the same, the input mask is described
beforehand:
The current value is shown on the display, while the first digit is flashing. By pressing
the keys
"
" a
nd
"
",
this digit can be increased or decreased. With the key
"
",
you can switch to the next digit in order to set the desired value with the keys
"
"
and
"
"
. With the key
"
",
you can switch to the previous digit in order to set the
desired value with the keys
"
"
and
"
"
. If you selected the last digit (on the right)
and you press the key
"
"
, you can set the multiplier k (kilo) or m (mega) with the
keys
"
"
and
"
"
in case of higher values, if necessary. In order to accept the value
and to finish entry, please press the key
"
"
again
.
If a set value was not accepted or if another value is displayed after the entry, it is possible that the set
value exceeded resp. fell below the limit of the setting range.
