Belmash MCS-400, Operating Manual

Page: 19 / 64

EN
19
BELMASH MCS-400
To prevent access to moving chain 10 the machine includes protective guard 8, that is adjusted
depending on the height of the blank to be cut.
For cutting wastes collection, the bag mounted on shell 20 is used.
For machine carrying, handle 14 is used. The machine can be manually carried to a required
place being lifted by handle.
Machine frame 1 has hooks intended for hanging control pedal 13 from one side and angle
device 6 – from the other side. There are also hooks for power cord and pedal cord winding
during machine transportation or storing.
There is hook 52 at the corner of working table 2 for sweep brush hanging.
Machine carrying when holding it by working table IS NOT ALLOWED!
Electrical diagram is shown in figure 2.
7. PRESTARTING PROCEDURES
Fail-free machine operation largely depends on correct maintenance and timely malfunctions
elimination.
To prepare for operation it’s necessary to perform:
• assembly;
• startup.
7.1 Machine assembly (fig. 3, 4)
Remove the machine and set of parts from packaging.
The machine is equipped with guide bar having an opening for driving sprocket
lubrication or not having one. In case of the presence of lubrication opening,
prior to guide bar mounting, perform sprocket lubrication (subsection 9.2)
• Connect supports 3 and 3a with crossbar 3b by means of washers and screws, attach
them to the machine and fix them by thumb screws 21;
• Mount bushings 49, washers 28 and wheels 25 on axle 24;
• Mount supports 22 and 23 on axle 24 and bolt them. Then attach them altogether to the
machine and fix them by thumb screws 21;
• Pump wheels 25 providing 3-4 bar pressure;
• Unscrew transportation screws 26 and remove bushings 52 that fix working table 2;
• Mount and fix upright frame 11 (do not tighten the screws) by bolts and washers to
machine frame;
• Raise working table 2 and unscrew screws 34, move bracket 33 aside (fig. 4);
• Remove cover 35;
• Insert guide bar 9 into the groove of working table 2 and fix it on the machine frame 1
by means of plate 36 by washers and bolts 32 through service opening in the machine
frame;
• Secure guide bar 9 at upright frame 11. Moving plate 50 along the grooves, set guide bar
9 perpendicular to working table 2 using angle template. Tighten the screws;
• Tighten the fastening bolts of upright frame 11;