HCP-1801 HD/SD SDI Control Probe
Guide to Installation and Operation
Page 24 of 27
HCP-1801
Refresh Rate
– select the desired refresh rate from
the pull-down box. The choices are:
[Fast, 1 sec, 2 sec, …, 9 sec, 10 sec.]
Streaming Priority Control
– Click the
Take control
from Slot [##]
checkbox to force the Densité
Controller for this frame to assign more bandwidth
for this card’s streaming output. Only one card in the
frame can use this feature. It has no effect unless
you have selected
Fast
for the refresh rate. The
actual slot number of this card, as shown in the
window title bar, will appear when the checkbox is
ticked.
Display CC
– select the checkbox to display closed
captioning in the thumbnail display.
Display XDS
– select the checkbox to display XDS in
the thumbnail display.
General – RALM
Set up the characteristics of the Remote Audio Level
Meter (RALM) that is shown in the ALM tab in the
Display Area.
RALM Connections
Each of the eight AES signals can be sent to the
RALM or not (OFF)
Reset All Overload Counters:
click this button to
reset all the overload counters on the ALM display to
zero. See the next section for instructions on setting
up the overload counters.
Meter Ballistics Config
Type
– select a type of meter from the pull-down list
Upper Zone Limits
– select the crossover level
between the upper and middle zones of the meter
(the range of values shown in the pull-down list
depends on the type of meter selected)
Lower Zone Limits
– select the crossover level
between the middle and lower zones of the meter
(the range of values shown in the pull-down list
depends on the type of meter selected)
Color samples
– the three samples show the current
selected color for the upper, middle and lower zones
of the meter.
•
Click on the color sample of a zone to open
a color selection panel to choose a different
color for that zone
Overload Cursor
– The overload cursor appears on
the meter as an arrowhead in the meter scale. The
two pulldown boxes set the position of the overload
cursor on the left and right meters. If the audio level
on that channel goes above the cursor, the Overload
Counter at the top of the meter is incremented.
RALM Remote Control
AES1 to AES8
– check the boxes to turn the
