Belden grass valley Kaleido-IP X120, Installation & Service Manual

Page: 32 / 110

32
IP Network Setup
Configuring a Multiviewer’s IP, Date, and Time Settings with XAdmin
5 Under Date and Time , select the appropriate time zone and format for your location.
6 If this Kaleido-IP is meant to monitor HLS sources, enable NTP synchronization: next to
NTP synchronization , click Enabled , and then type the NTP server’s IP address.
7 Click Save .
The new settings are saved locally.
8 Click OK .
9 The Apply settings button becomes available.
10 Click Apply settings .
The multiviewer must be restarted for changes to the network configuration to take
effect. A message appears prompting you to reboot the system immediately.
11 Click OK .
Your Kaleido-IP restarts.
12 In XEdit, a URL path can be used to identify a source located on a remote server to
access HTTP, RTSP, or RTMP streams. When using a URL, the multiviewer’s DNS server
configuration must be configured to allow the multiviewer to be able to resolve the
URL to the stream server’s current network IP address.
If your network uses a proxy server, then you must configure the proxy server’s URL.
a Click Configure , under DNS and proxy configuration .

The DNS and Proxy Configuration page appears.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not reboot after 10 seconds
or so, try clicking
Apply settings again after a minute or two, until the
multiviewer reboots.