Belden grass valley Kaleido-IP X120, Installation & Service Manual

Page: 21 / 110

21
Multiviewer Cabling
Introduction
This chapter shows how to interconnect the multiviewer with its associated equipment.
Cabling Diagram
Typical cabling diagram for a Kaleido-IP X320 / X120 with two optional Media Ports ( LAN5 & LAN6 ).
The location of the optional Media Ports ( LAN5 & LAN6 ) depends on the network interface
option card that has been ordered / installed. See Network Interface Card Installation
Location in the Server , on page 71.
Kaleido-IP Multiviewer Ethernet Port Usage
On the rear panel of non-virtual machine (VM) Kaleido-IP multiviewers are Ethernet
connections that should be used as follows:
• The management port LAN1 is used for multiviewer management: that is, any PC that
uses XEdit or XAdmin to configure this multiviewer and any Kaleido-RCP2 / RCP-200
must have IP connectivity to the
LAN1 port. The management port LAN1 port can be
used for media streams also.
Media Network
Media Network
Media Network
Media Network
Management
Network
Inline PSU
PC
DP 3 & 4
(Do Not Use)
DP1
Head1
DP2
Head2
1
st
Power Supply Module 2
nd
Power Supply Module
LAN5 LAN6
LAN1 LAN2
LAN3 LAN4
Video Serial Port A USB
Ports
IPMI
Media Network
LAN6 LAN5
OR