Belden grass valley Kaleido-IP X120, Installation & Service Manual

Page: 23 / 110

23
Kaleido-IP X320/X120
Installation & Service Manual
Commissioning the Multiviewer
Connect the multiviewer as follows.
1 With the Kaleido-IP frame installed in its designated rack position, power up the frame.
The multiviewer starts up. The startup sequence takes approximately four minutes.
2 Connect your Kaleido-IP multiviewer’s Ethernet ports to two or more Ethernet switches
(one Management Network and one or more Media Networks ) according to Kaleido-IP
Multiviewer Ethernet Port Usage , on page 21 and Cabling Diagram , on page 21).
3 Connect a client PC, and the Kaleido-RCP2 (if available) to the switch on LAN1 . You can
also connect a mouse and a keyboard to your Kaleido-RCP2.
4 Connect one of the DisplayPort outputs of the multiviewer to a display that supports a
resolution of 1920 × 1080 @ 60 Hz (HDTV) (see Cabling Diagram , on page 21).
Note:
To disconnect an RJ-45 network cable connected to the optional
LAN5 or LAN6 media ports, you may need to use the blade of a flat
screwdriver to reach the cable’s locking mechanism.
Notes
• The Kaleido-RCP2 is an optional device, and may not have been shipped
with your Kaleido-IP system. For information on this and other options for
your multiviewer system, contact your Grass Valley sales representative.
• You may need to upgrade your Kaleido-RCP2 devices (if available) to the
latest firmware. See Software and Firmware Updates , on page 15. Refer to
the Kaleido-RCP2 Guide to Installation and Operation for instructions on
how to determine the firmware level, and how to perform the upgrade.
See
Related Documentation , on page 15.
Notes
• Depending on your display type, you may use the DisplayPort-to-HDMI
that shipped with your system, or DisplayPort-to-DVI adapters (not
included).
• Although the Kaleido-IP unit has four DisplayPort outputs, only the first
two DisplayPort outputs are used.
• To disconnect a display cable at the DisplayPort outputs, you may need to
use an object (e.g., the blade of a flat screwdriver) to reach the cable’s
locking mechanism.
• Disconnecting and reconnecting any Kaleido-IP DisplayPort-to-HDMI
adapter may require a restart. The adapter cables must be properly
connected when the multiviewer restarts. If you connect such an adapter
after the multiviewer has restarted, the display will remain blank.