GUIDE TO INSTALLATION AND OPERATION
16
| IPG-3901
255.255.255.255 is refused (not applied).
Unicast addresses are accepted. If the ARP is not
resolved, it will be highlighted in Orange.
IP Stream to SDI
Multicast addresses are accepted (224.0.0.0 through
239.255.255.255).
Only ETH1 IP address and ETH2 IP address are
accepted as the Unicast address.
Stream Port (S. Port)
(primary and
redundancy stream)
0 to 65535
10000
IGMPv3 Source
(primary and
redundancy stream)
0.0.0.0 to 255.255.255.255 0.0.0.0
Format
SD, HD, 3G
HD
When you have entered new values into the table (you can change multiple parameters on different gateways), the
changed values are highlighted, and the Apply and Cancel buttons at the top of the table are active.
•
Click
Apply
to accept your changes
•
Click
Cancel
to discard your changes and
leave the original values unchanged
5.3 Network Config panel
5.3.1 Network Config panel – Settings tab
Network Configuration
Enter the IP Address, Mask and Gateway for the two
ethernet ports (ETH1 and ETH2) on the IPG-3901 into the
data boxes.
•
After any change, you must click
Apply
to confirm the
new values, or
Cancel
to leave the existing values
unchanged. Pending changes are displayed in red.
Operation Mode:
The ETH 2 port is used to provide
Redundancy or Aggregation. If the ETH2 port is not
required, set the operation mode to OFF.
Parameter
Values
Default value
Operation
Mode
OFF
Redundancy
Aggregation
OFF
See
Gateway Config panel – Gateways tab
for more information about the ETH2 Operation mode.
Figure 5-4 Network panel – Settings tab
