BELARUS-1021/1021.3
Operating manual
74
5.10.3 Procedure of programming integrated display KD8083
Procedure of programming integrated display KD8083
- remove the control panel cover;
- press the panel button (1) (Figure 5.10.1) and hold for at least two seconds;
- the five-digit display will show the mode of precise total service hours of the engine. At
that, the LED goes on located next to the “T” symbol.
- repeatedly pressing the panel button (1) cycles through the programmed parameters “T”,
“K1”, “K2”, “K3”, “K4”, “R”, “Z1”, “Z2” and then again “T”;
- to enter the required value of the selected parameter, press the panel button (2) (Figure
5.10.1), at that the lower order digit (the first from right) of the selected display parameter will
start flashing at 3 Hz;
- using the panel button (2), set the required value of the lower order digit of the selected
parameter;
- briefly press the panel button (1), at that the second digit from right of the digital display
will start flashing;
- using the panel button (2), set the required value of the second digit from right of the
adjusted parameter;
- briefly press the panel button (1), at that the third digit from right of the digital display
will start flashing;
- using the panel button (2), set the required value of the third digit from right of the
adjusted parameter;
- fix the entered setting of the parameter by pressing the panel button (1);
- pressing the panel button (1) again will switch to the next parameter;
- to exit the programming mode, switch to the mode of precise total service hours of the
engine, then press the panel button (2) and hold it at least two seconds. At that, the five-digit
display will show “8.8.8.8.8” for one to four seconds, and all LEDs of the PTO dials must go on.
This indicates that the new programmed parameters are fixed and will be used by the display to
show information.
Attention:
if you exit the programming mode in a manner different from the above, the
newly entered parameters will not be saved.
Table below lists programmable ratios of the display KD8083 for BELARUS-1021/1021.3
tractors.
