BELARUS-1021/1021.3
Operating manual
161
The clutch pedal free travel as measured with the engine off must be 40 to 50 mm. If the
value is too high or too low, adjust the clutch pedal free travel.
To adjust the clutch pedal free travel, proceed as follows:
- remove the cotter pin and remove the finger (2) (Fig. 8.4.23) disconnecting the rod (5)
from the lever (1).
- loosen the locknut (4).
- unscrew the bolt (8) so that the pedal rod (6) move upwards up to stop against the cab
floor.
- turn the lever (1) counterclockwise until it stops, that is, when the release bearing touches
the clutch release levers.
- unscrewing the fork (3), align the holes in the plug and the lever (1), and then screw the
fork into the rod (5) by 5 ... 5.5 turns (i.e., shorten the rod). Connect the fork (3) with the lever (1)
using the finger (2).
- assemble the leverage of the clutch pedal in reverse order.
Make sure that the clutch pedal securely returns up to stop against the floor at the area of
pedal free travel. Otherwise, adjust the servo spring force (7) with the bolt (8) or change the
position of the bracket (9) by turning it relative to the fastening bolt axis.
1 — lever; 2 — pin; 3 — fork; 4 — locknut; 5 — rod; 6 — pedal rod; 7 — servo spring; 8
— bolt; 9 — bracket.
Fig. 8.4.23 — Check/adjust clutch pedal free travel
40...50 mm
paso libre