GYRO WRAP™
Signature
®
Series
1MANUL248
Belanger, Inc. * PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
51
Maintenance
Tips & Warnings
•
Over-cleaning or excessive rubbing can do more harm than good
•
To prevent marring, make sure cleaning sponge, cloth, etc., are grit-free
•
Abrasive materials such as steel wool, abrasive brushes, etc., can wear and harm finishes
•
Do not scour painted surfaces
•
Do not under any circumstances use strong solvents such as thinners, aggressive alkaline, acid or abrasive cleaners
•
Do not use a power washer, high-pressure, or heated water as this can wear and cause harm to the powder coated surface
•
Always use a test surface first
•
Use nothing stronger than white spirits to assist with stubborn stains. Cleaning with white spirits should be carried out in
shade and during cooler temperatures using a soft cloth and gentle wiping only. It is also recommended that a small non-
visible area be tested initially to ensure that no color change or damage will occur
If you have any questions or concerns regarding how to clean powder coat equipment
please call Belanger Technical Support / Aftermarket Group for additional assistance.
Powder Coating Repair
Repair, fading, blemishes and light scratches, to powder coating.
Repair faded powder coating
Faded powder coating means, the surface of the coating has oxidized. This is usually only the
surface (2-3 microns). By rubbing with cutting compound the surface will be removed and new
paint exposed with its original color. However, if the original coating was a matte finish it will now
have been polished to a gloss.
Repair light scratches and blemishes to powder coating.
Scratches may be deeper than 2-3 microns. Use cutting compound to remove the powder
coating down to the level at the bottom of the scratch. A fine rubbing down paper may speed up
the process (800 to 400 grit, no coarser), but the job will need to be finished with cutting
compound to remove the fine scratches left by the rubbing down paper.
Repair Powder Aerosol
Cleaning prior to painting.
The original paint needs to be clean prior to ‘touch up or touching in’ repainting. Indoor
components may have been polished with polishes containing Silicone. Silicone will repel any
further painting and must be removed from the local area. Clean the surface by washing it with a
detergent and a Scotch-Bright™. ‘Multi Clean’ is specifically designed for cleaning material prior
to painting. Thoroughly rinse and dry the surface. If solvents are needed to remove marks, a soft
cloth dampened with Isopropyl Alcohol may be used. Solvents containing esters, ketones, or
chlorinated solvents must not be used without consulting the paint manufacturer, as these are
too aggressive and will melt the paint. A small discrete area should be tested first.
Repair Powder
The surface contaminants may need to be removed by abrading with fine rubbing down paper
‘400 grit’. If the component has been damaged, causing chipping or cutting to the paint, the
loose flakes should be removed. ‘Ugly steps’ where the paint has been chipped need to be
feathered. Coarse rubbing down paper ’80 grit’ will do this faster, but it will leave noticeable
scratches. Finer paper will produce better results, 250 grit paper is a good compromise, (this will
wear smooth quickly, so replace it frequently).
Primer preparation
When the original paint edges have been rubbed down smooth and a step is not noticeable,
remove the dust, apply a light coat of paint/primer, and allow it to dry. This will show how well the
area has been prepared. Continue rubbing down and applying light coats, until the edges of the
damaged paint have disappeared. Applied properly, at this stage all physical signs of repair can
be lost.
