Beko METPOINT BDL portable, Instructions For Installation And Operation Manual

Page: 49 / 108

Operation BDL
METPOINT® BDL 49
14.2.2.8 Configuration of analog sensors
Short overview of the possible Type settings including examples.
Except for BEKO-Digital , in this case see Chapter 12.2.2.1 Selection of the sensor type (Example BEKO-
Digital sensor type) and 12.2.2.6 Dew point sensor with the BEKO-DIGITAL type .
The alarm (see Chapter 12.2.2.4 Alarm settings ) and recording buttons (see Chapter 12.2.2.3 Recording
measuring data ), the resolution of the decimal places and the short name or the value name (see
Chapter 12.2.2.2 Denoting the measuring data and determining the resolution of the decimal places ) are all
described in Chapter 12.2.2 Sensor settings .
For the marking of the text fields, see Chapter 12.2.2.7 Marking and setting text fields !
14.2.2.8.1 Type 0 - 1/10/30 volt and 0/4 – 20 mA
Main menu  Settings  Sensor settings  C3  Type text field  0 - 1/10/30 V
Scaling of the sensor (here, for example,
type 0 – 10 V - corresponds to 0 – 250°C)
can be found in the data sheet of the con-
nected sensor.
For scale 0 V , please enter the lower scale
value and for scale 10 V the upper scale
value.
The ext. Sensor supply voltage is switched
on when the sensor requires this.
With the Set-value-to button (offset) , the
measured data of the sensor can be set to
a certain value.
The positive or negative difference of the
offset is indicated.
With the reset button, the offset can be
reset to zero.