Page
16 ©
BEKA 2019 All rights reserved!
...a product of
9.2
Assembly of Beka Stream H barrel version
Step 1:
Push the follower plate (fig. 15, pos. 6) into the barrel.
Step 2:
Attach suitable lifting straps or chains to the bracket (fig. 15,
pos. B).
Step 3:
Push the pump (fig. 15, pos. 1) with a suitable lifting device
through the central bore in the barrel cover (fig. 15, pos. 3).
Step 4:
Push the pump pipe (fig. 15, pos. 7) through the follower plate
(fig. 15, pos. 6). Make sure that the barrel cover (fig. 15, pos. 3)
does not slide downwards.
Step 5:
Push the pump (fig. 15, pos. 1) with cover (fig. 15, pos. 3) down
until the cover rests on the barrel.
Step 6:
Tighten the wing screws (fig. 15, pos. 4) until the cover (fig. 15,
pos. 3) is firmly fixed on the barrel.
Step 7:
If available, fold the tie rods (optional accessory) upwards and
fix them with the straps (fig. 15, pos. 5) of the cover (fig. 15,
pos. 3).
Step 8:
Push the pump (fig. 15, pos. 1) completely down until the pump
pipe (fig. 15, pos. 7) rests on the bottom of the barrel. Then pull
the pump up again by approx. 1 cm.
Step 9:
Fix the pump (fig. 15, pos. 1). Tighten the two clamping screws
(hexagonal socket AF 6 – fig. 15, pos. 2).
Step 10:
Remove lifting straps or chains.
9.3
Assembly of Beka Stream H container version
Screw the device securely to the ground using the 4 fastening bores (fig. 16).
The ground has to be as even as possible.
The fasteners must be matched to the ground.
6
1
5
7
3
2
4
B
Figure 15
Figure 16
