51
Display
Description of function
‘AcSEt t’
Access Set Time
Sub-menu that enables the timer
setpoint ‘Set t’ to be adjusted
from the display mode. A
separate security code prevents
unauthorised access.
See section 3.5.7
'uP or dn'
Direction of count
Determines whether the timer
counts from zero upwards, or
from the set time setpoint Set t
downwards.
See section 3.5.8
‘dISPLAY.2’ Lower display
(Set t)
Turns the lower display, which
shows the timer setpoint ‘SEt t’,
on or off.
See section 3.5.9
‘ContinuE’
Continue cycle
Determines how the timer
powers-up after a power supply
interruption. When ‘OP.OFF’ is
selected, both optional control
outputs will be open. When
‘OP.rEStOr’ is selected, both
control outputs will be returned
to their status when power was
removed. After power restoration
the timer will always return in the
stopped condition.
See section 3.5.10
‘LOC-rSEt’
Local reset
When turned ‘On’ the timer may
be reset from the display mode
by simultaneously operating the
Up
and
Down
push-buttons for at
least two seconds.
See section 3.5.11
‘CLr.Gtot’
Resetting grand total time
This function resets the grand
total time to zero when ‘CLr YES’
is selected, and ‘SurE’ is entered
to confirm the instruction.
Note:
Once cleared, a grand
total time can not be recovered.
See section 3.5.12
Display
Description of function
'COdE'
Security code
Defines a four digit numeric code
which must be entered to gain
access to the programmable
functions. Default code 0000
disables the security function and
allows unrestricted access to all
programmable functions.
See section 3.5.13
