Operating hours
Explanation
Operating Job
Maintenance Job
to be performed
Remove
machine head
- Lint and thread waste
.
(e.g. with air blow gun)
Clean
the entire area 1 of the thread guides
under the thread sliding plate
8
Suctioning Device
Empty the container 2 of the suctioning
device
- Turn the lower part of the container
to the left and remove the lower part
- Empty the container
- Screw back the lower part
by turning it to the right.
8
Pneumatic System
- Check the water level in the
pressure regulator
3
- Clean the filter insert 4
- Check the leak tightness of the
system
Make sure that the water level does not
rise up to the filter insert 4.
- After pressing the drain screw 5,
blow out the water under pressure
from the water separator.
Dirt and condensate are discharged by
means of filter insert 4.
- Separate the sewing unit from the
compressed air supply.
- Press in the drain screw 5.
The pneumatic system of the sewing
unit
must be pressureless.
- Unscrew the water separator 6
- Extract the filter insert 4.
Wash and blow out the contaminated
filter cup and filter insert
with petroleum ether
(no solvent!).
- Reassemble the water separator
and connect the maintenance unit.
40
500
500
56
Summary of Contents for 1281/5-1
Page 39: ...35 1 ...
