BEHLMAN BL10000 Series, User'S Manual And Technical Reference Manual

Page: 16 / 59

10
TABLE 3-1. CONTROLS AND INDICATORS
REF CONTROL/INDICATOR FUNCTION
1 Circuit breaker ON: Connects input power to unit.
OFF: Disconnects input power from unit.
2
CONSTANT CURRENT indicator Lights to indicate protective circuits are
automatically operating to provide rated
current and distortion-less output during an
overload condition.
3 “ FREQ ” control Used to establish output frequency.
4
OUTPUT switch ON: Connects output power to control chassis
rear panel output terminals.
OFF: Disconnects output power at rear panel.
5
OVERLOAD LATCH indicator Lights to indicate short circuit protection for
overload conditions that disables the output.
Overload latch is reset by removing load and
recycling power.
6
OVER-TEMP indicator Lights to indicate over temperature condition
and removal of output power. Output power is
automatically restored on termination of
over-temperature condition.
7
Digital readout meters VOLTS: Provides output voltage (RMS)
display.
AMPS: Provides output current (RMS)
display.
FREQ: Provides output frequency display.
7a Meter Select Switch 3 position rotary that selects which output phase
is displayed on readouts.
8 “ VOLTS ” control Used to establish desired output voltage.
9 Line drop compensation & phase adjust
trim pots.
Allows for output adjustment due to IR drops in
the load lines. One adjustment provided for each
phase. Trim of output phase angles.
10 Output RANGE switch ( optional) Selects output voltage range. Supplied with T5D
option units only.
11 DC Power input Terminal block Connect to +/-250VDC from power section.
Pre-wired on single phase input units. C8 - C10
12 AC output terminal block Connects AC output to user’s load. CAUTION
use top screws only to prevent loss of hardware
inside unit.
13 Remote Connectors (optional) Analog, IEEE-488 , or RS-232 control ports.