BEGA BETEX 22 ELDi, User Manual

Page: 8 / 79

8
3. Installation

Remove packing material and place the induction heater on a non-ferrous, stable, flat surface. The
box will normally contain the heater, a yoke or a set of yokes, the temperature probe, a pair of
heat-resistant gloves and a small container of lubricant.

Check the supply voltage and current meet the specifications on the type plate to be found on the
back of the machine.

As there are a large number of plug types, not every Bega induction heater is provided with a plug.
When the heater is not provided with a plug, a suitable plug has to be affixed by a qualified
electrician.

The wires should be connected as follows, there are 3 options depending on what type of cable
the heater is supplied with:
120V/230V 1 phase Heaters
120V/230V 1 phase Heaters (cCSAus)
Brown Phase Black Phase
Blue Neutral White Neutral
Green/yellow Ground Green Ground
Black “1” Neutral
Black “2” Phase
Green/yellow Ground
400, 450, 500V 2 phase Heaters 480, 600V 2 phase Heaters (cCSAus)
Brown Phase Black Phase
Black Phase Black Phase
Green/yellow Ground Green Ground
Black “1” Phase
Black “2” Phase
Green/yellow Ground

Make sure that the supply cable cannot come into contact with the bearing that is to be heated.
Insert the plug into a shockproof wall socket.

Use the main switch to switch on the current. The machine will emit a short bleep and the display
will show a “pre-set goal temperature” set by the manufacturer.

Connect the temperature probe by inserting the plug in the socket. Make sure that – and +
correspond on both plug and socket

The induction heater is now ready to be used in the temperature function mode.