BEGA BETEX 22 ELDi, User Manual

Page: 11 / 79

11

Always make sure that the workpiece has no direct contact with the plastic housing of the heater.

When heating cycle is ready, follow the above instructions in opposite order to take of the heated
work piece. Wear protective clothing like heat resistant gloves because the workpiece is hot now.
(The supplied gloves are suitable for 150°C (302°F).

Always treat yokes carefully. Falling, jolting, etc, can damage them. Always put the yoie away
immediately after use.
5.2. Maximum weights for swing-arm models
Table showing the maximum permitted weights on the horizontal supports & swiveling yokes:
Swing Arm Yoke Size
Heater
Series
On
Supports
20 mm 30 mm 40 mm 50 mm 60 mm 70 mm 80 mm
22 ESDi 65 kg 5 kg 10 kg 15 kg 20 kg 25 kg n/a n/a
24 RSDi 150 kg 10 kg 15 kg 25 kg 40 kg 45 kg n/a n/a
38 ESD 150 kg 10 kg 15 kg 25 kg 40 kg n/a 50 kg n/a
38 ZFD 300 kg 10 kg 20 kg 30 kg n/a 60 kg n/a 80 kg
40 RSD 350 kg 10 kg 20 kg 30 kg n/a 60 kg n/a 80 kg
40 RMD 600 kg n/a n/a 30 kg n/a 60 kg n/a 80 kg

To avoid the heater from tipping and damage to the yokes and the hinge construction, the
maximum weight for each size yoke is restricted.

Parts with a higher weight can rest on the horizontal supports (if fitted), or be supported by a
non-metallic rope from a crane, avoiding any weight on the yoke.
Diagram showing how the work piece can be supported:
22 ESDi & 24RSDi & 38 ESD 38 ZFD , 40 RSD & 40 RMD