80-4280-10, Rev. 4
10
SAFETY PRECAUTIONS
WARNING
WARNING
Installation and service instructions
are for use by qualified personnel
only. To avoid injury and electric
shock, do not perform any servicing
other than that contained in this
manual.
CAUTION
Hot surfaces! Surfaces of equipment
may be at an elevated temperature
depending on operating conditions
and environment. Allow to cool
before servicing.
STORAGE INFORMATION
Beck actuators should be stored in a clean,
dry area where the temperature is between -40°
and 85°C (-40° to 185°F).
Group 22 actuators should be stored in an
upright position and should not be stacked.
Damage due to moisture while in storage is
not covered by warranty.
INSTALLATION—MECHANICAL
There are many considerations regarding
proper mechanical installation—see the
instructions beginning on page 12 for details. Refer
to the outline dimension drawings for physical
dimensions and required clearances.
INSTALLATION—ELECTRICAL
See the instructions beginning on page XX for
details regarding electrical installation.
CAUTION
For maximum safety, the Beck
actuator body should be grounded.
Use the green grounding screw
in the wiring compartment of the
actuator.
CAUTION
Always close covers immediately
after installation or service to prevent
moisture or other foreign matter
from entering the actuator.
CONDUIT ENTRIES
Conduits are provided for power and signal
wiring. Temporary plugs are installed in the conduit
entrances at the factory for shipping only and are
not intended for permanent use. Prior to actuator
operation, all conduit entrances must be properly
sealed in accordance with National Standards or
Regulatory Authorities.
PRECAUTIONARY INFORMATION
