7
8
9
11
5
10
«click»
«click»
Fasten the sensor on the base by sliding the
sensor downwards until it clicks.
The sensor has to be attached firmly.
On the SLAVE module, plug the connector and clip
on the plug to cover the hole.
1. Cut the flexible tube if necessary.
2. Insert the cable into the flexible tube.
SLAVE = connected to the master module
On the MASTER module, plug both connectors.
Position the cable wires as shown in order to prevent
water infiltration and crushing of the wires.
MASTER = connected to the door controller
3. Position the flexible tube, clip on the clamp and
fasten the screws.
4. Fasten the flexible tube on the other end as shown.
Make sure the flexible tube is not detected.
MASTER = connected to the door controller
Lock the sensor onto the mounting base by fastening
the screw.
The flexible tube should not hang in the pinch zone, because it could cause unwanted detections.
