10
2x
3x
1x
x
5x
1x
HOW TO USE THE REMOTE CONTROL
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
DELETING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
After unlocking, the red
LED flashes and the sensor
can be adjusted by remote
control.
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
If you do not know the access code,
cut and restore
the power supply
. During 1 minute, you can access
the sensor without introducing any access code.
= field width: 2.35 m
To end an adjustment session,
always lock the sensor.
Enter the existing code
x = number of flashes = value of the parameter
full reset
partial reset
It is recommended to use a different access code for each module
in order to avoid changing settings on both modules at the same time.
