6
MASTER
7
7
5
«click»
«click»
TEACH-IN
Close the cover starting on the
narrow side. Do not hesitate to push.
Remove the positioning aids from
the base.
Before launching a teach-in, make sure that:
- the door is closed (use the service mode if needed).
- both relays are connected to the door controller and the master-slave cable is connected between the modules.
- the detection field is free of snow buildups, heavy rain, snowfall, fog or other moving objects or people.
During the teach-in the sensor learns its environment. If an object is positioned permanentely near the door, the field
size will be adapted accordingly. Launch a teach-in after changing the environment or the sensor position or angle.
* A teach-in on the MASTER configures both the MASTER and the SLAVE. A teach-in on the SLAVE only configures
the SLAVE.
Launch a teach-in on the MASTER module by push button or remote control*.
1.
Wait until the LED flashes green, then
indicate the edge of the door wing with your hand
.
2.
Wait until the LED flashes green again and
activate an opening and closing cycle of the door
.
3.
Wait until the LED goes out.
The service mode deactivates the safety detection during 15 minutes and can be
useful during an installation, a mechanical teach-in of the door or maintenance work.
To enter the service mode, push on the button for at least 2 seconds.
To exit the service mode, push again for at least 2 seconds.
The service mode is deactivated automatically when launching a teach-in.
To open the sensor again, position a
screwdriver in the slot and push until
the cover comes loose.
FINAL STEPS
ALWAYS TEST THE GOOD FUNCTIONING OF THE INSTALLATION BEFORE LEAVING THE PREMISES.
SERVICE MODE
