Be Cool All Aboard, User Manual

Page: 41 / 88

EN
41
NOTE:
• The shoulder strap don’t into the headrest red
guide part
Front view of the belt routing (Fig 7c) Please refer to 3a
- 3f, laying your baby in carseat correctly. (FIG 5a)
If in doubt, please consult either the child restraint
manufacturer or retailer.
NOTE:
• The belt is not twisted.
• The straps of the child safety seat are close to the
body without constricting the child.
• The shoulder belts are correctly adjusted and the
straps are not twisted.
• The shoulder pads are at the same level as your
child’s shoulders
• The buckle latches are engaged in the harness
buckle. Tighten the vehicle seat belt by pulling on
the diagonal seat belt section.
Forward facing Group II . III 15-36kg Installa-
tion with
FIX and Vehicle 3 point belt
Press the fix adjust button down “a” , Also, “b” press
the arrow direction can adjust the length of the fix
connector. Use the same system to adjust the length
on both sides of the Isofix connector. (FIG.8a)
Fasten the connector points into the Isofix points of the
car to secure the installation. (FIG. 8b)
Car seat is adjusted to Position 1.
Have your child sit down in the child seat.
Put the Car Seat on the vehicle seat, align it with the
ISOFIX interface in the vehicle seat and push forward.
“Click” will be heard when the FIX Conne -ctors are
locked.(FIG.8c)
NOTE:
• Shake the child safety seat to make sure it is safely
attached and re-check the green safety buttons to
make sure that both of them are completely green.
Seat your child in the carseat, and child’s back, shoul-
ders and haunch lean to carseat. Pull out the harness,
Make sure the belt is worn through under the armrest
of the car seat, the shoulder strap across the handrail
above, and the shoulder strap cross the headrest side
8
IM 2086.00 ALL ABOARD bo.indd 41 8/1/19 11:18