BAYKAL
EDITION NO :
HGL
SECTION :
DATE OF ISSUE :
November 2009
PAGE :
89
Figure 6.6.6.1
!
DO NOT loosen the edge bolts excessively, as otherwise the blade may fall
down causing injury.
•
The operator and co-operator should hold the blade with one hand, while
taking out the edge bolts completely with the other hand. The blade can now be
taken away.
NOTE:
In re-fitting the top blade, the above procedure is applied in reverse
order.
6.6.6.2. Changing the bottom blade:
•
Lift the cutting beam to uppermost position.
•
Set the backgauge to maximum distance.
•
Turn off the main switch and lock it up.
•
Remove the finger protection grid and shadowing wire.
•
Take out all blade fixing bolts (see in
Figure 6.6.6.2
) under the table in front of
the machine, EXCEPT one bolt in the middle.
•
One of the operators, at the rear of the machine, should hold the blade in its
place.
•
The other operator, in the front of the machine, should take
out the center bolt and go to the rear of the machine.
•
The operators should hold the blade by the edges, and take it away.
Top blade fixing bolts
Adjustment
nuts
Bottom Blade
Summary of Contents for HGL C Series
