BAYKAL HGL C Series, User Manual

Page: 42 / 104

BAYKAL
EDITION NO : HGL SECTION :
DATE OF ISSUE : November 2009 PAGE : 42
Label
(Electrical
Diagram)
Designation
Function (Figure 6.5.3.6)
7A2
Digital Controller
P9521
It controls back-gauge distance from the table.
This distance decides the cutting width.
10A2
Digital Controller
P400
It adjust blade gap for determining cutting
thickness
3S9
Back-gauge backward
button
When this button is pressed, the backgauge moves
backward
3S10
Back-gauge forward
button
When this button is pressed, the backgauge moves
forward
4K1
Stroke adjustment
timer
It set the cutting length
4S1
Cutting Control Switch
Position 1.
Series or repetitive cutting
Position 2.
One-off cut (single)
Position 3. Manual cutting (Inching)
4S4 Beam-up button It is used for raising the beam
4S5 Beam-down button It is used for lowering the beam
3S4 Pump-stop button When pressing, the main pump stops
3S5 Pump-start button When pressing, the main pump starts up.
2S2
Front Emergency stop
button
In case of emergency, when pressing, all
machine functions and controls will be
inactive and the main pump will stop.
2S3
2H1
Control on
After emergency stop button is pressed, in
order to operate the machine, the button must
be pressed. The button initializes the
emergency stop module.
2H2
Reset lamp (Safety
switch)
It indicates that the rear light guard should be
reset. When it illuminates, press the reset
button on the light guard transmitter branch.
4H1
2S5
Reset button (Beam-
up) and lamp
Because of any reason (power failure etc.) If
the beam standstills at anywhere, this button
must be pressed in order to operate the
machine again. When this button is pressed the
beam goes to its upper point.
3S11
Inside illumination
switch
When turning on, lamp inside the machine will
lit up.