BAYKAL HGL C Series, User Manual

Page: 52 / 104

BAYKAL
EDITION NO : HGL SECTION :
DATE OF ISSUE : November 2009 PAGE : 52
Feeding…..
5.
Put the plate on the work-table and feed it until touching the back-gauge
arms (see Figure 6.5.4.11 ). For correct cutting, the plate must touch the
back-gauge arm at least minimum two points.
! Do not push the plate excessively. In some thickness, plate can be bent
resulting unwilling or incorrect cutting width.
Figure 6.5.4.11
Pressing pedal …
6. After being sure of putting the plate on its place, press the footswitch (see
Figure 6.5.4.12
). Keep it pressed until the beam finishes its down-up
movement cycle.
If you release footswitch at any moment of this cycle,
the beam suddenly will retract (or rise) from its position to the top
standstill point.
In continuous cutting mode
, if you keep the footswitch pressed the beam
repeats down-up cycle for the pre-determined value on the digital controller.
How much time the beam will wait at the top standstill point is determined
by the time relay inside the electrical cabinet.
In single cutting mode,
keep the footswitch pressed until the beam finishes
its down movement (stroke). After finishing down movement you can
release the footswitch.