BAYKAL
EDITION NO :
HGL
SECTION :
DATE OF ISSUE :
November 2009
PAGE :
48
6.5.4. Operating the machine
6.5.4.1. First start-up and getting ready to work:
Figure 6.5.4.1
Figure 6.5.4.2
Figure 6.5.4.3
!
The machine must be first started-up and be put into service by
authorized and qualified personnel.
PROCEDURE:
Before putting the machine into service, perform following items
sequentially.
a)
Switch on the main switch in the way shown in the
Figure 6.5.4.1
.
The
reset lamp
shown in
Figure 6.5.4.3
will lit. (If not, there is either a
bulb failure or a disconnection in the electrical circuitry).
b)
Check the rear side of the machine and make sure that the safety switch of
the rear fence is engaged. Push the
rear reset button
shown in
Figure
6.5.4.2
;
the reset lamp
will be off. (If it remains lighted, check the back
gauge area against anything that prevents the transmitter and the receiver
from contact.)
Summary of Contents for HGL C Series
