Fitting the fascia.
1.
There are two hooked brackets on the top
rear of the fascia. Locate the hooks into the
brackets at the top of the heater (See figure
12).
2.
The fascia is secured using the two screws
with bright metal finish. These are located as
in figure 13.
3.
Locate the fuel support as in figure 14.
4.
Place the loose pebbles onto the fuel
support. It is not necessary to use all the
pebbles supplied.
Important Note:
The pebbles are for decorative
purposes only. There is a choke risk to
young children. Make sure they cannot
gain access to them.
Page 12
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 14. Fitting the fuel support.
Figure 13. Securing the fascia.
Figure 12. Fitting the fascia (Fascia
may differ from that shown).