!
The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3 core
cable.
!
The wires in the cable are coloured in
accordance with the following code: -
Live =Brown
Neutral = Blue
Earth = Green /Yellow
!
The electric supply must be safely routed from
the heater to an electrical socket.
Moving the Cable Guide
At the base of the heater you will find the electric
cable which runs through a rectangular plastic cable
guide. The cable guide is fitted into the rectangular
slot on the right side of the heater. If required this
can be moved and put in the rectangular slot in the
centre or left hand side of the heater. For removal
and fitting please see below.
Removing the cable guide
1.
Before moving the cable guide please note that the
lip of the cable guide is on the outer edge of the base
(See figure 1- Item 1).
2.
To remove the cable guide push and lift the tab on
the bottom of it and the cable guide will open (See
figure 1- Item 2).
3.
Lift the electric cable clear of the cable guide.
4.
Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1- Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the lip of the cable guide has to be fitted against the
outer face of the base (See figure 1- Item 1).
1.
Gently pinch the sides of the cable guide (See
figure 1 - Item 4) and push into the desired
rectangular slot.
2.
Place the electrical cable into the guide and close the top.
Page 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 1. Removing and
positioning the cable guide.
Item 1
Item 2
Item 4
Item 3
