specifically excluded from the guarantee.
To replace the light bulb.
1.
To gain access to the light bulb, remove the loose pebbles from the fuel support.
2.
Remove the fascia in the reverse order to that shown on page 12 & 13.
3.
Remove the lower cover plate from the front
of the heat engine. To do this remove the two
screws (See figure 19).
4.
Replace the light bulb with a B22 100Watt,
240Volt, triple life, Bayonet fitting type bulb
with a clear finish .
5.
Fit the fascia (See pages 12 & 13).
6.
Place the pebbles back on top of the fuel
support.
2. My heater is on but there is no light or
heat.
The first thing to do is check the wall socket.
To do this plug in a known working appliance.
If the appliance you have plugged in works then there is a good chance that the problem
lies with the 13Amp fuse in the heater plug. If either fuse or socket is suspected, have
them checked by an electrician.
3. My heater is on but there is no heat.
A cut out device is fitted to the heater to prevent damage due to over heating. If it
operates due to an obstruction in the airflow, the heater must be turned off and allowed
to cool for 15 minutes and the obstruction removed before restarting.
Page 15
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 19. Lower cover plate