Baur PD-TaD 80, User Manual, Page: 39 / 74

PD-TaD 80 Connecting the system
822-188-3 39 / 74
No. Cable Step
1 Protective earthing
cable of the VLF HV
generator Earth the VLF HV generator.
Further information: User manual for the respective VLF HV generator
2 Protective earthing
cable of PD-TaD 80
(flat copper strip) Connect the PD-TaD 80 to the station earth (close to the test object cable
screen).
Further information: Chapter Earth system (on page 34)
On the VLF HV generator:
– –
If present, connect the external emergency off unit to the VLF HV generator
(
port).
If you are not using an external emergency off unit, ensure that a jumper
plug is inserted into the
port on the VLF HV generator.
3 Connection cable
C19
– C20G
Connect the VLF HV generator (mains supply) to the Power Box (port
depends on the connection cable).
On the laptop:
4 USB cable Use the USB cable to connect the laptop to the VLF HV generator.
5 Ethernet cable Use the supplied Ethernet cable to connect the laptop to the Power Box
(
Laptop port).
– –
If you do not want to run the laptop off its battery, connect the laptop to the
Power Box to establish a power supply. To do so, use the connection cable
with the C14G plug.
At the PD-TaD 80:
6 PoE cable Connect the PoE cable:

to the Power Box ( PD Detector port) and

to PD-TaD 80 ( Power Box port)
This is used for power supply and data transmission at the same time.
7
–
Connect the HF filter to the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 80 (on
page 48)
8 HV connection cable of
the VLF HV generator Connect the screen of the HV connection cable to the Screen (HV Cable)
port.
9 See above Connect the HV connection cable to the HF filter at the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 80 (on
page 48)
10 Short-circuit cable of
PD-TaD 80 On the PD-TaD 80, remove the short-circuit cable from ports HV IN and
HV OUT .
At the far end of the test object:
11
–
Clean the cable termination of the phase to be tested carefully.
12
–
Attach the anti-corona hoods of the anti-corona protection device to the
cable termination of the phase to be tested.