Baumer PF55S, Operation Manual

Page: 88 / 105

Menu Description Password level /
BCP command
DAC1 4mA DAC1 out 4mA calibration point
n Current output 1 (4 mA)
n Calibration point 1 (zero flow rate)
L5 C1CP1
DAC1 20mA DAC1 out 20mA calibration point
n Current output 1 (20 mA)
n Calibration point 2 (maximum flow rate)
L5 C1CP2
FW update Firmware update
If the function is activated, the firmware can be
uploaded to the SD card (
name.file
).
The BCP interface is activated with the com-
mand
FWUPD = name.file
L 4 FWUPD
7.6.12.1
System
menu - additional BCP commands
The following menus are also available as an BCP command in the
command input of the BCP software:
Menu Description Password level /
BCP command
Device Unique
Identity KEY
Device unique identity key L 0 UIKEY
Device hardware
configuration
Device hardware configuration L 0 HWSET
Device hardware code Device hardware code L 0 HWCOD
Calibr.execution
status memory
Calibr.execution status
This function checks the internal calibration
status of the sensor.
n
CALXM = 1
valid calibration
This is the default value to avoid calibra-
tions that are not required.
n
CAKXM = 0
invalid calibration
If the function is zero, the calibration func-
tion must be started with the
CALIC
BCP
command.
L 6 CALXM
Select the function
code
Selection of the function code L 0 FCODS
Select the enable
state of func.
Selection of the function release L 6 FNESS
Operation
Menu navigation > System menu
05.03.2020 Flow sensor PF55S 88