PCD41
www.baumer.com
33
5 Programming mode
This chapter will inform you on how to program your controller. Ope-
ration parameters are set on the programming level. The program-
ming level consists of 3 programming ields. Access is protected via
a 4-character code.
1
st
programming field
Here it is possible to select and modify all operation parameters. The
operation parameters that are disabled for the operator are also dis-
played.
2
nd
programming field
The individual operation parameters for operator access on the ope-
rator level are disabled or enabled here.
3
rd
programming field
All functions and values conditioned by the machinery as well as in-
terface parameters are programmed here.
Switch on programming
➜
Press
key.
„Code“
is displayed.
No code is entered when instrument is delivered ex-works; thus you
may skip the code request by pushing the
key. The code is set in
programming line 40.
Upon installation of a code, it will only be possible to switch to the
programming level by using the correct code.
Enter Code
Enter code via the keys
and
.
Press
key for conirmation. The device will now switch from the
operating to the programming mode.
Wrong Code
If a wrong code has been entered,
„Error“
will keep on being displa-
yed as long as the key
remains pushed.
●
After 15 s, the counter switches back to the operating mode.
Correct code unknown
If the correct code is unknown, please send counter back to the
supplier or perform a reset of the factory setting.
Select programming lines
Select the programming line needed via the
key.
The corresponding line number will then be displayed. Please keep
the
key pressed for quick sweep.
Switch back within
By keeping the
key pressed and pushing the
key, it is
programming lines
possible to jump back within the programming lines.
Modify operation
Select decade to be modiied via
key. The selected decade lashes.
parameters
Enter value by pushing the
key. Press
key for conirmation.
Leave programming
It is possible to leave programming at any time by pushing
.
Reset to factory setting
Turn on instrument and push keys
and
simultaneously. All
values already programmed are set back to factory setting. „ClrPro“
is displayed.
