PCD41
www.baumer.com
31
4 Operating mode
The following chapter will inform you on the operation.
●
The controller is automatically on the operating mode after the
voltage supply has been turned on.
In the operating mode it is possible to:
-read and, if necessary, to clear the current display status;
-read and, if necessary, to clear the peak;
-adjust the display for the initial and inal values;
-to read and modify the limit values P1 and P2.
It is possible to disable all operation parameters on the programming
line (line 11-16).
Key functions
Parameter reading
It is possible to switch to the next operation parameter with
key.
Peak value reset
1.
2.
Have the peak value displayed.
Press
key.
Parameter setting
1. Have parameters displayed.
2.Press
key and select desired decade; the chosen decade
position lashes.
3.Press
key and enter value desired.
To set further decades, repeat steps 2 and 3.
4.Conirm the parameters entered via
key.
Should no conirmation occur within 15 s, the previous setting
will remain valid.
Reading of operation
parameter
1. Press
key. An infotext will appear for approx. 1 s regarding
the displayed operation parameter (e.g.: F for the current mea-
surement).
F - Current measurement
After having turned on the instrument or upon selection via the
key,
appears for 1 s, afterwards the current measure-
ment.
Read
Reset
HIGH - Peak memory
➜
Press
key.
HIGH appears for 1 s on the display, afterwards the peak value.
➜
Press
key.
Read
Example
bFdn - Display adjustment initial value
➜
Press
key.
bFdn appears for 1 s on the display, afterwards the initial value.
When measuring rotational speed, 0...10 V correspond to a speed
of 0...1000 rpm. The setting of the initial value remains at 0.
