GB16
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.
PREPARING THE CABINET FOR FITTING
Connection to the terminal block
If the hob is already provided with the two power supply cables required, follow the instructions included in the supply cable bag.
Connect the cables to the two terminal blocks on the underside of the appliance.
IMPORTANT:
only for 400 V 3N connection~ use one power supply cable only (connecting it to the terminal block of the main electronic module) in addition to 3 x 1.5 mm
2
wiring
for connecting the main terminal block to that of the auxiliary electronic module. For electrical connection, follow the instructions enclosed with the 3 x 1.5 mm
2
wiring.
For the electrical connection, use an H05RR-F cable as specified in the table below.
INSTALLATION
WARNING
-
Install a separator panel under the hob.
-
The lower part of the product must not be
accessible after installation.
-
In case of installation of an undertop oven,
do not interpose the separator panel.
•
Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could
damage them.
•
The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.
•
In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit.
•
Do all cabinet cutting work before fitting the hob, and carefully remove any shavings or sawdust.
•
IMPORTANT: For installation in worktops made of marble or similar materials, do not use the screws provided, but contact the after-sales service and request
bonding kit 4812 310 19277.
After bonding the brackets in the position indicated, leave the silicone to dry for around 24 hours before proceeding with installation of the appliance.
ELECTRICAL CONNECTION
WARNING
-
Disconnect the appliance from the power supply.
-
Installation must be carried out by qualified personnel who know the current safety and installation
regulations.
-
The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the
regulations provided in this chapter.
-
The power cable must be long enough to allow the hob to be removed from the worktop.
-
Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
-
Do not use extension cords.
min. 5 mm
min. 20 mm
mi
n. 5 mm
3 x 1.5 mm
2
400 V 3N ~
230 V ~ / 230-240 V ~ / 400 V 2N ~ / 230 V 3 ~
Summary of Contents for ESPIF 8950 IN
Page 3: ...3 1 2 3 X 4 ...
