USER MANUAL BATMODE 2S/2S+ SYSTEM
19
5.
Exclusively BATmode 2S+:
Use the temperature sensor cable to connect the analog temperature sensor input of the
BATmode 2S+ with the corresponding temperature sensor output of the antenna disc.
6.
Exclusively BATmode 2S+:
Optionally, precipitation data can be acquired by the BATmode 2S+ via the analog input or
USB/RS485 or USB/422 interface. For this purpose, a precipitation sensor has to be connected
to BATmode 2S+. For connecting, please refer to the manual of the precipitation sensor.
Only use authorized precipitation sensors und connection wires, since the use
of different devices can cause system failure, damage and loss of data.
7.
To simplify the parameterization of the BATmode system peripheral pc devices (mouse,
keyboard, screens,
…)
can be connected to the free USB and Minidisplay ports, optionally.
8.
If it is intended to use wired LAN connection to remotely access the BATmode system, connect
a corresponding Ethernet cable to the LAN port (RJ45, not included in delivery) of the
BATmode.
9.
Finally, connect the power supply to the BATmode.
3.2.2
When measuring at more than two measuring points with UltraSoundGates
116Hnbm/116Hnbm-r
1.
Initially, using a USB cable to connect the upstream port of the USB hub to one of the
UltraSoundGate ports on the front panel of the BATmode (see Figure 1).
2.
Use the remaining USB cables to connect the UltraSoundGates 116Hnbm to the downstream
ports on the USB hub.
3.
If you utilize GM50 microphone discs, connect the XLR-input connectors of the
UltraSoundGates with the single end of the microphone cables. Subsequently, connect both
connectors at the other end of the y-wires with the microphone and reference signal speaker
connectors of the GM50 microphone discs. Due to different pin numbers, it is not possible to
connect the microphone cable incorrectly. If you are using GM90 microphone discs, use the
microphone cables to connect the microphone input of the UltraSoundGates to the
microphone connector of the GM90 microphone discs.
When using tower microphones TM10 or TM20, connect the built-in cables to the XLR
microphone input of the respective UltraSoundGate.
