1-2
920512-768
Operator Manual
Safety Precautions
WARNING – ELECTRIC SHOCK HAZARD:
WARNING – BURN HAZARD:
WARNING – CHEMICAL BURN HAZARD:
WARNING – SLIPPING HAZARD:
Always set building electrical-supply disconnect switch and console master power switch to OFF before
performing any preventive maintenance functions within the compartments. Electrical shock can cause
serious injury.
Disconnect all utilities to washer before servicing. Do not service washer unless all utilities have been
properly locked out. Always follow local occupational health and safety regulations, as well as electric
and plumbing codes.
After pressing STOP touch pad, wait until water flow stops before opening doors. Hot water/steam may
be sprayed through door opening if doors are opened too soon.
Before performing any service on unit, wait until chamber and piping cool to room temperature.
Except for emergency, do not open door when cycle is in progress. In an emergency, stop cycle by
pressing EMERGENCY STOP pushbutton and wait for safety delay to elapse before opening doors.
Hot water and steam could be sprayed through door opening if doors are opened too soon.
Inner surfaces of washer are very hot after cycle completion. Operator should wear appropriate per-
sonal protective equipment (PPE), including gloves and faceshield and avoid all contact with inner walls
when entering chamber to unload washer.
Pipes may be extremely hot.
Always use non-foaming chemical for effective cleaning and proper pump and water level control opera-
tion. Follow manufacturer's recommendations for amount of chemical to be used.
Washer chemicals are caustic and can cause adverse effects to exposed tissues. Do not get in eyes, on
skin or attempt to swallow. Read and follow precautions and instructions on chemical label and in Mate-
rial Safety Data Sheet (MSDS) prior to handling chemical, refilling chemical container or servicing
chemical injection pump or lines. Wear appropriate Personal Protective Equipment (PPE) whenever
handling chemical or servicing chemical injection pump and lines.
Wear appropriate personal protective equipment (PPE), including gloves and faceshield, when using a
descaling product. Avoid contact with eyes or skin. If spilled or splashed, flush with water for 15 min-
utes. If swallowed, DO NOT induce vomiting. Administer an alkali with plenty of water. Seek medical
attention immediately.
To prevent slips, keep floor dry. Promptly clean up any spills or condensation. If spilled liquids are deter-
gents or other chemicals, follow safety precautions and handling procedures set forth on detergent or
chemical label and/or Material Safety Data Sheet (MSDS).
