ULTRASAMPLER® sample collection system
164
Measuring System MAK TIGER 3003 Service manual, SA 131128, 10.03.2020
Instructions for mounting and dismounting:
1. First remove threaded milk pipe adapter, if still attached to FLM. To do
this, open the clamp fasteners (2) on both sides and remove the pipe
connections from the FLM.
Attention:
Do not lose the seals and put them back carefully when reassembling.
2. First screw the threaded milk pipe adapters with the union nuts on both
sides of the pipe connections.
3. Then fit the FLM (not forgetting the flat gaskets (5)) and secure with the
fastening clamps (2). It might be easier if the pipe supports/anchors are
slightly loosened first.
Tighten again at the end.
Dismounting:
1. First take out the FLM by removing the fastening clamps (2) on both
sides. It might be easier if the pipe supports/anchors are slightly loos-
ened first.
2. Then, if necessary, remove the threaded milk pipe adapters from the
FLM.
Attention:
Do not lose the seals and put them back carefully when reassembling.
