Barox Kommunikation RY-LGSP23-10G, User Manual, Page: 230 / 383

barox Kommunikation
Publication date: Sept, 2015
Revision A1
219

Timeout
The number of seconds remaining before sampling stops and the current sFlow owner is
released. While active, the current time left can be updated with a click on the
Refresh-button. If locally managed, the timeout can be changed on the fly without affecting
any other settings.

Max. Datagram Size
The maximum number of data bytes that can be sent in a single sample datagram. This
should be set to a value that avoids fragmentation of the sFlow datagrams. Valid range is
200 to 1468 bytes with default being 1400 bytes.
Port Configuration

Port
The port number for which the configuration below applies.

Flow Sampler Enabled
Enables/disables flow sampling on this port.

Flow Sampler Sampling Rate
The statistical sampling rate for packet sampling. Set to N to sample on average 1/Nth of
the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate is requested, the
switch will automatically adjust it to the closest achievable. This will be reported back in this
field.

Flow Sampler Max. Header
The maximum number of bytes that should be copied from a sampled packet to the sFlow
datagram. Valid range is 14 to 200 bytes with default being 128 bytes.
If the maximum datagram size does not take into account the maximum header size,
samples may be dropped.

Counter Poller Enabled
Enables/disables counter polling on this port.

Counter Poller Interval
With counter polling enabled, this specifies the interval - in seconds - between counter
poller samples.

Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved values.