Barox Kommunikation RY-LGSP23-10G, User Manual, Page: 107 / 383

barox Kommunikation
Publication date: Sept, 2015
Revision A1
96

Timeout
Timeout is the number of seconds, in the range 1 to 1000, to wait for a reply from a RADIUS
server before retransmitting the request.

Retransmit
Retransmit is the number of times, in the range 1 to 1000, a RADIUS request is retransmitted
to a server that is not responding. If the server has not responded after the last retransmit it
is considered to be dead.

Deadtime
Deadtime, which can be set to a number between 0 to 1440 minutes, is the period during
which the switch will not send new requests to a server that has failed to respond to a
previous request. This will stop the switch from continually trying to contact a server that it
has already determined as dead.
Setting the Deadtime to a value greater than 0 (zero) will enable this feature, but only if
more than one server has been configured.

Key
The secret key - up to 63 characters long - shared between the RADIUS server and the
switch.

NAS-IP-Address (Attribute 4)
The IPv4 address to be used as attribute 4 in RADIUS Access-Request packets. If this field is
left blank, the IP address of the outgoing interface is used.

NAS-IPv6-Address (Attribute 95)
The IPv6 address to be used as attribute 95 in RADIUS Access-Request packets. If this field is
left blank, the IP address of the outgoing interface is used.

NAS-Identifier (Attribute 32)
The identifier - up to 255 characters long - to be used as attribute 32 in RADIUS
Access-Request packets. If this field is left blank, the NAS-Identifier is not included in the
packet.
Server Configuration
The table has one row for each RADIUS server and a number of columns, which are:

Delete
To delete a RADIUS server entry, check this box. The entry will be deleted during the next
Save.

Hostname
The IP address or hostname of the RADIUS server.

Auth Port
The UDP port to use on the RADIUS server for authentication.

Acct Port
The UDP port to use on the RADIUS server for accounting.

Timeout
This optional setting overrides the global timeout value. Leaving it blank will use the global
timeout value.