Barox Kommunikation RY-LGSP23-10G, User Manual, Page: 218 / 383

barox Kommunikation
Publication date: Sept, 2015
Revision A1
207
DSCP: If a frame matches the QCE then DSCP will be classified with the value displayed
under DSCP column.

Modification Buttons :
You can modify each QCE (QoS Control Entry) in the table using the following buttons:
: Inserts a new QCE before the current row.
:
Edits the QCE.
: Moves the QCE up the list.
: Moves the QCE down the list.
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the QCE listings.

Port Members :
Check the checkbox button in case you what to make any port member of the QCL entry. By
default all ports will be checked

Key Parameters :
Key configuration are discribed as below:
Tag Value of Tag field can be 'Any', 'Untag' or 'Tag'
VID Valid value of VLAN ID can be any value in the range 1-4095 or 'Any'; user can enter
either a specific value or a range of VIDs
PCP Priority Code Point: Valid value PCP are specific(0, 1, 2, 3, 4, 5, 6, 7) or range(0-1, 2-3, 4-5,
6-7, 0-3, 4-7) or 'Any'
DEI Drop Eligible Indicator: Valid value of DEI can be any of values between 0, 1 or 'Any'
SMAC Source MAC address: 24 MS bits (OUI) or 'Any'
DMAC Type Destination MAC type: possible values are unicast(UC), multicast(MC),
broadcast(BC) or 'Any'
Frame Type Frame Type can have any of the following values
1. Any
2. Ethernet
3. LLC
4. SNAP
5. IPv4
6. IPv6
NOTE: All frame types are explained below:
1. Any : Allow all types of frames.
2. Ethernet : Ethernet Type Valid ethernet type can have value within
0x600-0xFFFF or 'Any', default value is 'Any'.
3. LLC: SSAP Address Valid SSAP(Source Service Access Point) can
vary from 0x00 to 0xFF or 'Any', the default value is 'Any'
DSAP Address Valid DSAP(Destination Service Access Point) can vary
from 0x00 to 0xFF or 'Any', the default value is 'Any'
Control Address Valid Control Address can vary from 0x00 to 0xFF or