Baroness LM66GC, Owner'S Operating Manual, Page: 70 / 85

Note:
First, tighten the screw at the center. Then,
follow the numerical order, first to the right
and then to the left, as shown below.
1 2
4miqko-002
Installing The Bed Knife_002
1 Bed knife
2 Screw
Removing/Installing The Small Cover (Left)
Removing The Small Cover (Left)
Insert an item such as a wooden hammer
handle into the reel cutter to prevent it from
turning, and remove the lapping bolt, the
disk spring, and the gear retainer collar.
5
1
2
3
4
xg9isz-005
Removing The Small Cover (Left)_001
1 Reel cutter
2 Lapping bolt
3 Disk spring
4 Gear retainer collar
5 Wooden hammer
1.
Unscrew the 4 bolts, and then detach the
small cover (left).
2
1
xg9isz-006
Removing The Small Cover (Left)_002
1 Small cover (left)
2 Bolt
Installing The Small Cover (Left)
Caution
See the list in Tightening torques.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Attach the small cover (left) temporarily to
the frame with four bolts.
2
1
xg9isz-006
Installing The Small Cover (Left)_001
1 The small cover (left)
2 Bolt
Important
Be sure that there is no gap between the oil
seal fitted in the small cover (left) and the gear
retainer collar.
Install the gear retainer collar to the reel
cutter shaft while adjusting the position of
the small cover (left).
Tighten the 4 bolts which have temporarily
been attached to the small cover (left).
2.
1.
2.
3.
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-20
Maintenance (Mower)