Baroness LM66GC, Owner'S Operating Manual, Page: 27 / 85

Roller
Inspection of Rollers
Bearing wear due to frequent use or bearing
damage caused by water infiltration may
prevent the roller from rotating smoothly.
Inspect the roller and, if necessary, replace
parts such as oil seals and bearings.
Make sure that there is no abrasion nor
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no wear nor
damage of the oil seal.
Make sure that there is no wear nor rust of
the bearing.
Make sure that there is no play in the roller
shaft.
Drum
Inspection of Drum
Make sure that the drum is not cracked or
damaged.
Make sure that there is no abrasion or
adhesion of the drum.
Make sure that there is no play in the fit of
the drum and the bearing.
Tire
Inspection of Tires
Check the pneumatic pressure of the tires.
Make sure that there are no cracks,
damage or abnormal wear.
Tire size Pneumatic pressure
Tire for
traveling
4.10/3.50-6
120 kPa (1.2 kgf/
cm
2
)
Brake
Inspection of Brake
Danger Danger
Make sure that the brake wire is not cracked
or damaged.
If the wire is cracked or damaged, replace it
with a new one immediately.
1.
2.
3.
4.
5.
1.
2.
3.
1.
2.
Caution
Park the machine on a flat place.
Do not park the machine on a slope.
Pull up the brake lever and make sure that
the brake can operate completely.
Pull the brake lever up to the top and make
sure that it can lock the brake lever.
Make sure that the brake is not applied
even slightly after releasing the brake lever.
Wire
Inspection of Wire
Make sure that the wire is not cracked or
damaged.
If the wire is cracked or damaged, replace it
with a new one immediately.
Engine
Inspection of Engine-Associated Parts
For details on handling the engine, please
refer to the Engine's Owner's Manual.
Check the fuel system parts for loosened or
cracked joints and leakage. Replace the
parts if necessary.
Blow compressed air to clean any grass or
flammable materials that may be attached
on or around the muffler.
1.
2.
3.
1.
2.
1.
2.
Handling Instructions
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-5
Inspection Before Use