Baroness LM66GC, Owner'S Operating Manual, Page: 66 / 85

Installation of Bed Knife Base
Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
When handling the reel cutter (cutting
cylinder) or bed knife (bottom blade), wear
gloves to protect your hands.
Pay attention not to let the reel cutter (cutting
cylinder) catch your gloves. Otherwise, you
may injure your hand or fingers.
Caution
While operations are performed with the front
of the machine raised, there is a danger of it
falling.
Securely support the machine.
Caution
Refer to the Tightening Torque table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Important
Make sure that there is no binding at the cam
bushes in the frame of the mower unit.
Temporarily install the bed knife base
COMP onto the machine with the left and
right cutter pins and lock nuts.
Note:
At this time, tighten the lock nuts to the
heads of the cutter pins, but do not allow
the lock nuts to contact the cam bushes. 1.
2
3
4
1
kx7caa-001
Installation of Bed Knife Base_001
1 Bed knife base COMP
2 Cutter pin
3 Lock nut
4 Cam bush
Important
Install the bed knife base arm Assy parallel to
the frame.
During installation, be careful not to twist both
arms.
Insert the bed knife base arm Assy into the
bed knife base COMP.
Temporarily install the bed knife base arm
with the bolt of the fulcrum seat.
2
3
4
1
kx7caa-002
Installation of Bed Knife Base_002
1 Bed knife base arm Assy
2 Bolt
3 Spring washer
4 Washer
2.
3.
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-16
Maintenance (Mower)